Charging is the same Voltage at Battery, Boost point under hood, and directly at the alternator. If i unplug that connector it takes about 2min and then the Alternator starts charging 14V. The vehicle charges under 12.5V with connector X6524 plugged into Alternator. Power wire from Batt all the way to starter/Alt Ok. Changed 3 diffrent alternators 2 Bosch Reman and 1 Bosch New. Ive been pulling my hair for a while on this one Getting fault codes: 281C Bit Serial Data Signal 281D Bit Serial Data Generator Signal. I need some help with a customers 05 330ci ZHP. The following components are connected across the bit-serial data interface with the DME/DDE control unit. Bit-serial data interface (BSD) The bit-serial data interface is a single-wire data bus with a data transfer rate of 1.2 kBd.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |